There are times and applications where an assembly needs to be run through conduit, panel enclosures or threaded through tight spaces. Having one end open allows installation of the cable itself followed by termination after placement.

When you know one end of the assembly, but are not sure of your length or which connector you need at the other end, our extensive line of pigtail assemblies should meet your requirements. One end is terminated as shown, but the other end is blunt-cut, ready to be stripped and terminated with a connector of your choice.

To determine your cable assembly part number, simply replace the XX at the end of the number shown with the length in inches you require. The cost of your assembly will then be quoted based upon that length. Overall tolerance is +2"-0, from